How to Make a Sensor (Part 3)

 

How to Make a Sensor (Part 3)

Is this your first time here? Welcome! The following blog post might not make sense, but you can catch up with this sensor series here.

So what did I do wrong today? Well, let’s talk about the things I did right! I covered all my joints in shrink tubing (no short circuit here!), I worked on a non-metallic table (again, no chance of a short circuit), and my soldering is getting much better!

I spent the entire day soldering a bunch of pretty wires to my Arduino Nano, and finally soldered a battery connector. After an entire day of hard work (read: soldering practice), all that was left to do was test my device with a battery…

Well, just watch the vlog to see what happened…

xxx

Jess